Is Purchasing Direct TV Satellite Signal Finder The Right Decision?
As suggested by the name, the direct TV satellite signal finder or
the satellite director, or the dish pointer, is a handheld device that has been
designed for tuning or locating the television satellites. It is quite helpful
when one is looking to get a better signal for their dish. However, at times
the satellite finder wouldn’t work if one is trying to aim the current DirectTV
Dish. Now, it might work right with the round dish or the non-SWM HD dish.
However, if SWM has been built in the dish itself, the satellite finder can
leave the users quite frustrated and without the picture on the TV.
What is Special About the
DirectTV SWM?
The satellite system of DirectTV has
been designed to remain different from the satellite systems that are used all
throughout the world. It is also quite different from the 1990s’ original
system of DirectTV. It is because it is meant to help the users save a lot of
money.
DirectTV became successful with people wanting
to have a bigger and bigger system, which took a huge amount of wire. Well,
unlike the cable TV system, the original system of DirectTV needed the wire
from the dish for literally every single television. Furthermore, increased
number of homes started coming pre-wired for the cable, and these weren’t
possible to be used for the DirectTV as they had the splitters and the single
cable which came into the house.
With DirectTV rolling out the HD service in the
late 2000s, they came in with SWM or the Single-Wire Multiswitch. This had the
tech which could put all of the needed signals for running every single
receiver in the home on a single wire.
Now, this cannot be used with the cable
television splitters as it is quite a similar type of tech that supports just
one wire in the house, and it has much simpler wiring. However, it also means
that the direct tv satellite finder doesn’t work herein.
Why wouldn’t it work?
The direct tv satellite signal finder is quite a
simple audio receiver. It features the look of the L-band signal that gets
produced through the satellite dish, which is based on the Ku-band signal,
which is received from the primary satellite of the DirectTV. If it ‘hears’ the
same, you will be able to see the meter move. Not more is there to it. It is
unfortunate that the SWM tech operates quite differently.
The SWM technology of DirectTV relies on the
receiver to request the signal before it is provided. Further, when the same is
provided, it can get used with any of the eight different kinds of frequencies.
So, the simple satellite finder, it doesn’t know what it has to do with the
information if it would hear, and it also doesn’t know how it can be requested.
For the fancy stuff, one will need the meter that comes with the DirectTV
Advanced Installation Meter, and it can be a little more expensive. However, it
does earn up the money and allows the user to zero in on signals from varied
types of dishes like that of the SWM-enabled dish of DirectTV. It will help one
to get the dish set up, so as to ensure that one can get down to watch what
exactly the user wants.
Is the direct TV satellite signal finder not good for anything?
The solid signal satellite finder will still
work for aiming the legacy dishes that don’t have the SWM tech built in there.
In case one has more than 1 wire that comes out from the dish, the meter will
be working right. One can even use it for most of the Dish equipment. For sure,
it will come with a simpler analog meter, and it wouldn’t help one to get best
of the possible aim on the satellite. However, on the other hand, being one of
the simple portable devices that wouldn’t take any power to run, and it is nice
to have the same in the tool kit.
Comments
Post a Comment